Half-Moon Leslie switch ??

[happyfreddy]

hi,

first chose is left switch half for the function of RING :
Connect pin 1 and 3 together. solder them to the RING
Pin 4 is soldered to GND = shaft

second chose is right switch half for function of PIN

solder pin 5 to GND = shaft

either pin 6 or 8 soldered to PIN

Mount the switch in that way that the slow function is at left side when switched
If not just turn the switch or solder the pin to the other pin 6 or 8.

[zoleeon]

To understand this halfmoon switch thing for HX3:

T, R, S not connected is STOP
R connected to the ground or sleeve is RUN(slow)
so I inserted a TRS cable in the footswitch input of the HX3 and shorted the ground to the ring and indeed the rotary start to run...but when I released it , no connection between T, R, S it was still in the run mode, and only when I did connect the ring to sleeve again, than stopped...maybe I have to do some global setup to my unit to listen to no connection between T, R, S?

and than kind of same with FAST

T. R, S connected is Fast, right?

so I connected the tip ring and sleeve, and rotary started run fast, than release the connections, tip ring and sleeve no connection between each other and the unit remained on Fast....what I am doing wrong? Or is my unit faulty?

If someone can help, please do so. Thank you in advance!

[happyfreddy]

HI

In this case the switches of Leslie are defined as
PUSH BUTTONS
They must be defined as real SWITCHES

[zoleeon]

HI

In this case the switches of Leslie are defined as
PUSH BUTTONS
They must be defined as real SWITCHES

Hi!

This is good news for me. I could not find this settings in the unit itself. Where can I change this leslie related setup?

Thank you!

[zoleeon]

In the editor I found something leslie related

editor 1.jpg

(368.84 KiB) 60-mal heruntergeladen

editor 2.jpg

(363.15 KiB) 57-mal heruntergeladen

but there seems to be defined as switches...

this editor is huge....sorry, It is easy to get lost in it...

[zoleeon]

HI everyone!

Just for those who are struggling to make a halfmoon switch for HX3.5 as I was...you need a double 3 way guitar switch, you have the schematic here in this topic, posted by Happyfredy and the one more information that in my case was missing it is that you have to enable latching mode in the editor, activate bit 0 in parameter #1502(thanks for this information to Christian from keyboardpartner)...mine was not activated by default, it was in a kind of toggle mode that is why I got the chaotic changes with the switch.

Hope that this will help others in my situation.

All the best!