Keyboardpartner-Forum

Hi,

anyone knows if it is possible to send the keyboard (note) data from the local keyboards (in my case 2 x fatar + fatarscan2) through the midi out socket (to feed an external device like a piano module or computer...) if so, would it be touch sensitive? This might sound like a silly question or weird thing todo, but when performing live it would be nice to combine the faster response fatar-hx3 organ with other sound midi modules, while being able to play all sounds from the same 2 keyboards. ..?


thanks for all advice,

best regards,

Alain

Hi
On MIDI OUT the Data from FATAR Keyboards appear incl DYNAMIC Value. So no problem to drive for eyample
piano expanders

Thanks happyfreddy for your reply, this sounds music to my ears, I have not been able to get midi signal to external device so far however, I probably did not set correct settings in remote, not sure if I need to or where...

best regards,

Alain

Don´t change the Jumpers besides the MIDI Jacks !!!
So as board is delivered the are in setiing MIDI OUT.

da häng ich gleich noch mal meine nicht beantwortete Frage an, ob man bei midi out den Schweller mitsenden kann, also die Lautstärke. geht bei mir nämlich nicht, immer max Pegel

Hi happyfreddy, I do not have a jumper-socket installed on my board... (above midi out socket)

regards,

Alain

Hi,
The socket is there !
It´s under the red USB socket direct left side the two MIDI Jacks.
On the socket are two jumpers set. Let them in their position = MIDI OUT funtion for the MIDI OUT Jack.

Changing the jumpers will set the MIDI OUT Jack as SECOND MIDI IN JACK

What appears on MIDI OUT besides FATAR Keyboard Data must be set via remote software
Not every data is possible to be sent

Hi happyfreddy, I found the jumpers behind the usb print, will not change 'em, but I've tried all midi settings, no midi note on-off data (or other data) is being sent through midi out...? Any specific setting I might have overlooked?

I also notice that the lower keyboard is slightly softer than upper, but did not see a seperate upper-lower volume setting or balance ?

thank you,

Alain

Hi,
Perhaps there something has changed since a extension board can be plugged.
Extensionboard contains a third MIDI Jack used as MIDI OUT too.
The configuration what appears on which MIDI OUT can be set in different way.
In moment Carsten is busy with moving his home/office adress so I can´t ask him
Please be so kind and wait till next week or so and he is ready again.

und meine Frage? zu blöd, um sie zu beantworten? ist doch für alle midi user wichtig