Keyboardpartner-Forum

I want to control the fast and slow leslie effect using the sustain pedal connected to the FootSwitch input.
I need to shut down to release a fast ef. Press again to release the slow ef.
Can it be set in the editor :?:

You have on back side of the Expander a stereo Jack for switching
the Leslie Effekt Slow - Fast - Stop

The shaft of Jack is GROUND
The ring switches against Ground RUN and STOP Modus
The Pin switches against Ground FAST - SLOW modus

The Fast - Slow Modus only happens when the RUN Modus is ON

In either position of fast - slow this modus will stop when the RUN Modus is OFF

So in Your case You only have to plug in a SWITCH with PIN and GROUND connection
The RUN Pin must then always being shortened to Ground

happyfreddy thank you for the advice