Keyboardpartner-Forum

I explain poorly.
I have connected all switches (tabs) to PL25 and PL26 that I want to use vibato upper vibrato lower and percussion reverb etc, but when I change function on Button / Switch Input Assignment / Remap nothing changes. how-to?

If using the real switches of the Hammond You must declare via editor those buttons
as real switches !!!
The default configuration is push button . So that´s the reason of no function

I've edited in Button Mask 0 Button Mask 1 for switches, is it more? the problem remains.

If any parameter has been changed You must send this group values to HX 3
When all finished You must finalize all

But before any operation make a backup as discribed in Editor with a name Your chose.
( default parameters and Your serialnumber, licenced etc )

Ok, start with move buttons in organ, maybe later edit in the deep.
Thanks

It´s allowed to connect from each switch of percussion panel til split switch a LED in series with
220 Ohms to VCC. Each switch switches against GND.
In this case use low current LEDs.

So if Your board is still configurated for buttons it must run.
The function of these switches will happen when You turn ON and promtly OFF the switch.
If the switch is held down nothing will happen because buttons work with rising edge
of signal.

Later when configurated as real switch the LED will show You switch is on or off

I find switch remap button on right side on edit program.
So all is great.

Now most of it is mounted and works well. but.
how do i switch between wersi, H-100 and B-3 mode in a good way with the reverse preset keys?

First You need the licence for H 100 mode
called extended licence
https://shop.keyboardpartner.de/epages/ ... e_Upgrades

without this licence no use of this part like H 100 etc of HX 3.5 is possible

The You have to study several manuals
http://wiki.keyboardpartner.de/index.ph ... _(deutsch)

- HX3.5 Backgrounder (deutsch)
- HX3.5 Mainboard Bedienungsanleitung als druckbares PDF
- HX3.5 Editor Bedienungsanleitung als druckbares PDF

In moment they only exsist in german version

important is in using the presets for different changes to define them
as OVER ALL PRESET - You must do this for every preset separatly !

ofcouse I have extended licence.
By over all presets do you mean param 1504 (2)?