Keyboardpartner-Forum

First of all; What a great idea and product.

I have the HX3.5 board in a Plexi "Midi expander" enclosure.

My issue is the Midi channel setting. In my band setup, Midi Ch.1 is reserved already for another device that cannot be changed.
So I try to set "MIDI Channel" on HX Plexi control panel to Ch.2. (so upper should be=2, lower=3 and pedal=4), but then no sound heard on any channels.
Trying to change midi channel in editor seems not do do any difference. In default Ch.1 setting, HX responds fine on Ch.1-3.
Any ideas about this issue?

Best regards
Heinz

hi
Normally any change of Midi Channels (1,2,3 or 2,3,4 or 3,4,5 etc ; channels must always follow directly)
will run.
We will control again those softwareparts and if there is any mistake You will get an update promtly

Thanks for the information. We have verified the issue. Will be addressed immediately with ScanCore update .15.

Thanks so much! It works perfectly now :D

Best regards
Heinz