Seite 1 von 1

Computer cannot recognise connected HX3 Expander module.

Verfasst: 10. Feb 2019, 23:20
von jon54
Hi - I'm wanting to edit CCs on my Hx3 module (firmware 4.25) but the Remote app is not detecting the module.
Can any one see where I'm going wrong?

Drivers are installed
Drivers installed.jpg
Module powered up and connected to computer using an M-Audio MIDI to USB device. I have both in/out MIDI plugs connected to the module.

Launch HX3.4 Remote app, but HX3 module not detected
HX3 Remote app fail scrSht.jpg
I have noticed that if I use the data entry knob or buttons on the module that the MIDI data LEDs on the M-Audio do not flicker!

Re: Computer cannot recognise connected HX3 Expander module.

Verfasst: 11. Feb 2019, 10:13
von m_g
You have to connect your HX3 directly via USB

Re: Computer cannot recognise connected HX3 Expander module.

Verfasst: 11. Feb 2019, 13:13
von happyfreddy
.... and don´t forget to include Your name and serial numbers / licences in marked fields !!!

Re: Computer cannot recognise connected HX3 Expander module.

Verfasst: 11. Feb 2019, 21:25
von jon54
m_g hat geschrieben:You have to connect your HX3 directly via USB
Ohhhh... I completely forgot that there is a mini USB socket on the module aaaannnnnd...BINGO!!... The Remote app sees the connect module.

Thank you so much :)

Re: Computer cannot recognise connected HX3 Expander module.

Verfasst: 11. Feb 2019, 21:27
von jon54
happyfreddy hat geschrieben:.... and don´t forget to include Your name and serial numbers / licences in marked fields !!!
These were all imported automatically when the remote app connected with the module. All OK :-)