von Fernando Vilaboy » 18. Jul 2023, 20:53
Hi!!
I'm finishing to instal a HX3.5 in an old Hammond CV keybed and A100 drawbars... finally with patient and reading this forum and thanks to happyfreddy and TatooHanes everything works...except the preset keys, that works but they are not in the right place: the upper B is in my D# (button 0 in 0 extern 60$), upper A# is in D button1, my C# is in the button 2 and then my B is in the button 8, A# in the 9, A in 10, going down till the E in the 15... and exactly the same with the lower but in the 1 extern 61$. I'm using a Preset 12-2 platinen connected to the PL 21...
My question is... there's a way to relocate or re asign the buttons on the Editor? I'm completely sure that the cable to the platinen Pin1 is key B and down.
Any help welcome...
Thanks!!!
Hi!!
I'm finishing to instal a HX3.5 in an old Hammond CV keybed and A100 drawbars... finally with patient and reading this forum and thanks to happyfreddy and TatooHanes everything works...except the preset keys, that works but they are not in the right place: the upper B is in my D# (button 0 in 0 extern 60$), upper A# is in D button1, my C# is in the button 2 and then my B is in the button 8, A# in the 9, A in 10, going down till the E in the 15... and exactly the same with the lower but in the 1 extern 61$. I'm using a Preset 12-2 platinen connected to the PL 21...
My question is... there's a way to relocate or re asign the buttons on the Editor? I'm completely sure that the cable to the platinen Pin1 is key B and down.
Any help welcome...
Thanks!!!