Hammond Halfmoon CU-1 an HX3

Antwort erstellen


Diese Frage dient dazu, das automatisierte Versenden von Formularen durch Spam-Bots zu verhindern.
Smileys
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:

BBCode ist eingeschaltet
[img] ist eingeschaltet
[url] ist eingeschaltet
Smileys sind eingeschaltet

Die letzten Beiträge des Themas
   

Ansicht erweitern Die letzten Beiträge des Themas: Hammond Halfmoon CU-1 an HX3

Re: Hammond Halfmoon CU-1 an HX3

von Christian » 13. Mai 2021, 09:49

The CU-1 I saw is single pole. That is why I soldered the diode between FAST and ON. It connects ON to ground in FAST position.

Re: Hammond Halfmoon CU-1 an HX3

von happyfreddy » 8. Mai 2021, 15:30

Hi
Yes of course !!! It´s the same when the RUN button is on.
The switch must be for opration Slow - Stop - Fast a 3 way type with a middle
position.

Re: Hammond Halfmoon CU-1 an HX3

von billyb » 8. Mai 2021, 12:49

okay , from the schematic , the ring remains ground in both fast and slow positions . and i assume ring must also remain
grounded for fast to function ?

Re: Hammond Halfmoon CU-1 an HX3

von happyfreddy » 8. Mai 2021, 11:31

If the break function is wanted the jack and switch must be configurated like this

viewtopic.php?f=3&t=531

I always use a 2 way gitar switch. This switch has 3 positions and two switches
inside , cost about 5 Euro

Re: Hammond Halfmoon CU-1 an HX3

von billyb » 8. Mai 2021, 10:05

did not know this was possible , so you end up using just one pole of the CU-1 ? also with the brake function ?

Hammond Halfmoon CU-1 an HX3

von Christian » 29. Apr 2021, 11:07

Weil manchmal danach gefragt wird:

Um den Halfmoon-Schalter von Hammond an der Rotary-Schalterbuchse des HX3 zu betreiben, sind folgende Änderungen nötig: Kabelverbindung zu den Schaltkontakten vertauschen: Chorale an Ring des 6,3mm-Steckers, Tremolo an Spitze. Diode (z.B. 1N4148) zwischen den beiden Anschlüsse einlöten, Kathode an Tremolo.

Nach oben