Keyboardpartner-Forum

Fine! Forgot that... After update, analog inputs are ENABLED by default. if using no drawbar pots, they must be disabled by the parameter 521.Sorry for the hassles.

Great :D
Last problem was a display instability (probably due to high impedance open analog inputs). So I did:
wen=1
521=255
and now everything is perfect. I am learning, also thanks to your kind assistance. :D
Regards
Angelo

Everything's right, but you have to enter the appropriate scan board parameter 519, as described here:

http://wiki.keyboardpartner.de/index.ph ... can2_board (example, set 519=1 for MIDI input).

After firmware update, parameter 519 is 6 which means hardware test loop.

During the Test Loop the HX3 orange led is on with slow intensity modulation and the 7 white leds on the panel light up sequentially. Nothing else happens. The display shows ScanBoard D - Hardware Test. I will try to leave the test running for a couple of hours but I suspect that something is wrong with the new firmware.
Thanks again
Best Regards
Angelo

Hi,
the firmware update to 3.46 has been successfull. And, using the teraterm macro, also entering licence codes (but not the Owner). Now the problem is: after booting HX3 enters a neverending Test Loop. Is it normal ? What to do ?
Thanks a lot
Regards
Angelo