HX3 Firmware

Antwort erstellen


Diese Frage dient dazu, das automatisierte Versenden von Formularen durch Spam-Bots zu verhindern.
Smileys
:D :) ;) :( :o :shock: :? 8-) :lol: :x :P :oops: :cry: :evil: :twisted: :roll: :!: :?: :idea: :arrow: :| :mrgreen: :geek: :ugeek:
BBCode ist eingeschaltet
[img] ist eingeschaltet
[url] ist eingeschaltet
Smileys sind eingeschaltet
Die letzten Beiträge des Themas
   

Ansicht erweitern Die letzten Beiträge des Themas: HX3 Firmware

Re: HX3 Firmware

von Angelo Cappello » 6. Mär 2014, 11:12

Hi Cartens,
many thanks for your kind answer.
Best Regards
Angelo

Re: HX3 Firmware

von bovist » 6. Mär 2014, 10:44

Angelo,

You will need the USB/serial adaptor cable, TeraTerm 4.7x program (freeware) and a Windows PC for this purpose. The HX3 module puts out current serial and licence numbers on serial interface when powering on or by reset (invoked by command "9999 <ENTER>" on terminal program). Just write them down or copy & paste from TeraTerm window. Without licence numbers, you will only get the demo with 2-minute time limit for Leslie sim.

Anyway, I keep track of all licences generated, so if you loose them, just email me.

Re: HX3 Firmware

von Angelo Cappello » 5. Mär 2014, 17:55

Hi,
I will explain my problem better. The wiki "HX3 board installation", under "Controller firmware updates", says: licence codes must be re-entered after AVR update as EEPROM is reprogrammed with defaults. Until now I did not need any licence code to use the module. Do you know if this reprogramming applies also to HX3 modules with all licences ? Perhaps in this case the codes are not stored in the EEPROM.
Thanks a lot
Regards
Angelo

HX3 Firmware

von Angelo Cappello » 5. Mär 2014, 10:44

I would like to update the HX3 firmware to ver.3.46. I've read that this requires re-entry of serial numbers (license numbers). Is it correct ? Were can I find them ?
I purchased the HX3 with all licences.
Thanks a lot
Best Regards
Angelo Cappello
Bologna, Italy

Nach oben